Your browser is not supported. Please update it.

4 July 2014

Adesto low-power CBRAM memory chips pass milestone shipment

Adesto Technologies has announced it has shipped 1 million units of its new low-power memory chip that it says can be used in IoT sensors, wearables and sterilized medical devices. The fabless manufacturer says the RM24x family of chips are so efficient that they operate on extremely small amounts of power ‘ enough to be harvested from their deployment environments, through actions such as motion or sunlight.

This means that the memory chips could be used in sensors that do not have batteries installed. We looked at STMicro’s EnFilm batteries last week, which were paper-thin but still took up a 25.7mm2 form factor. If the memory chips are as efficient as Adesto claims, then the size constraints of batteries can be thrown out the window ‘ enabling smaller devices and sensors using Adesto’s 2.5mm2 chips. Smaller size should also benefit the bill of materials.

To this end, Adesto claims the chips consume 100 times less energy than popular energy storage solutions (flash memory) without sacrificing speed and performance. If this low power requirement can be met by energy harvesting technology from the likes of Spansion, which we looked at last month, then the devices in which the new chips are deployed could enjoy operational lifetimes that are measured in years ‘ dependent only on the durability of the components, and not the battery as is usually the case.

Adesto’s main product is these Conductive Bridging Random Access Memory (CBRAM) chips, which it positions as a direct competitor to flash memory. CBRAM modules are programmable devices that can be used as independent modules on a PCB or embedded inside other chips. As a non-volatile storage system it can store data without a power supply, but so can traditional flash. It is currently cast in 130nm CMOS and sub-55nm architecture is in development.

CBRAM can write data to memory using 0.6 volts of electricity, compared to the much higher requirement for flash memory operation of around 10 volts that Adesto says is typical for flash. Evidently, this is the basis of their ‘up to 100 times less energy’ claim. The trade-off for its low energy usage is found in its storage capacity of only 1 megabit (125kB), which should still be plenty for IoT sensors storing data for a scheduled burst transmission.

But one major benefit of CBRAM is that unlike flash it can survive the radiation systems that hospitals use to sterilize equipment without corrupting the stored data ‘ although we have to take Adesto’s word on this as we lack the means to put their claim to the test. CEO Narbeh Derhacobian said this would allow CBRAM to power intelligent medical equipment or other technology required for use in sterile environments.

‘Distributors are stocking CBRAM and using them to replace Electrically Erasable Programmable ROM (EEPROM), particularly in Bluetooth LE applications. CBRAM is very cost-effective at low density. A 1Mbit EEPROM die size is 5 or 6 square millimeters, while the 1Mbit CBRAM is 2 square millimeters,’ Derhacobian told Electronics360, adding ‘over the next three or four quarters you will see a lot more announcements relating to CBRAM features.’

It remains to be seen whether this minnow can swim with the big fish in the silicon sphere, or whether a larger fish might swallow them up. Adesto was founded in 2007 after securing initial venture capital investment. Further investment has been provided by Altis Semiconductor, the manufacturer of Adesto’s CBRAM modules and Applied Materials. Derhacobian has gone on record to say that the company enjoys 45% gross profit margins, while providing its chips to over 300 customers.