Your browser is not supported. Please update it.

7 November 2005

Dust shows off mesh sensor architecture

One of the most high profile start-ups in the emerging wireless sensor network market, Dust Networks, has shown off a new mesh platform that it claims addresses reliability and performance problems associated with many approaches to these tiny monitoring devices.

Rob Conant, Dust’s co-founder, said that frequency hopping is the best approach for wireless networks when used for monitoring or tracking in industrial and commercial buildings. He believes the 802.15.4 ZigBee standard for industrial networking using low power, low data rate connections is inadequate for many applications and companies must take the next step to minute sensors.

“802.15.4 in fixed-frequency mode just isn’t viable,” he said. “If you rely on a single frequency and the convenience store next door turns on a Wi-Fi access point, your system will fall apart.” Dust, therefore, uses frequency hopping so that the signal is spread out over the entire band.

Dust’s SmartMesh-XR-based system can accommodate up to 250 nodes per manager device, and all nodes can be upgraded or reconfigured remotely with over the air software updates. Devices to run for five to 10 years on batteries.