Your browser is not supported. Please update it.

21 August 2014

Adtran’s FDV will help Telcos migrate faster to G.fast

Adtran has developed a technology called Frequency Division Vectoring (FDV), which will enable telcos to migrate to the upcoming G.fast from their existing VDSL2 vectored copper wire networks.

G.fast can deliver speeds of between 200 Mbps and 1 Gbps over copper wires, and the standard is currently being developed under the supervision of the telco’s ITU standards organization. Adtran already has some G.fast products in development and it plans to announce those products next year. Telco broadband providers that have invested in VDSL2 vectoring on their networks will eventually want to transition those networks to G.fast.

Adtran’s FDV technology enables G.fast and vectored VDSL2 to co-exist on the same copper line, and deliver G.fast speeds. ‘Carriers that have deployed vectored VDSL2 have a pretty substantial investment in that network,’ Adtran’s CTO Kevin Schneider said during an analyst event this week. ‘As they contemplate moving to a fiber-to-the-building (FTTB) architecture, they need to understand a migration path from their VDSL2 technology to G.fast.’

Telcos are interested in deploying fiber to the building and leveraging the copper wires that are already in place inside the buildings, because taking out the copper wires and installing fiber in the building is very, very expensive, disruptive and time consuming.

In an FTTB architecture, the cabinet launch point for vectored VDSL2 typically is around 200 meters from the building. The G.fast cabinet must be located right next to the building, because G.fast can only deliver those higher speeds over spans of 250 meters or less. Telcos won’t want to rip out all of the vectored VDSL2 they’ve put in to replace with G.fast, and they’re not particularly interested in maintaining two cabinet as launch points ‘ the vectored VDSL2 cabinet and then another G.fast cabinet closer to the building.

Problems also arise when the two technologies co-exist on the same line. ‘Typically, G.fast is defined to operate from 2 to 106 MHz; however, when it has to co-exist with the VDSL2, we end up with crosstalk,’ Schneider said, because VDSL operates in the lower frequencies, up to 17 Mhz. There is crosstalk between the two technologies in those lower frequencies, which degrades the speeds and performances of the two technologies.
‘The way to remedy that is to vacate that spectrum in G.fast, in a VDSL2 compatible mode,’ Schneider said. ‘So, G.fast performance won’t be as fast as it would be if we didn’t have to deal with the compatibility of VDSL.’

The solution Adtran has developed is to add G.fast as an ‘over-the-top’ channel to a vectored VDSL2 line, which it calls Frequency Division Vectoring. This puts the G.fast launch point in the same cabinet as the vectored VDSL; it eliminates the crosstalk issue and gives each technology full use of spectrum. ‘It affords virtually the same performance as G.fast that doesn’t have to co-exist with VDSL2,’ Schneider said. ‘I’ve erased the penalty, and yet I still have VDSL compatibility.’

Telcos can use FDV to deploy G.fast on their vectored VDSL2 networks more easily, speedily and at less cost, to be able to deliver higher speeds to broadband subscribers, Schneider said. Adtran will present the technology to the ITU later this month for inclusion in the G.fast standard.